Kenwood NX-5300-ISCK3 450-520MHz Intrinsically Safe NXDN, DMR, and P25 Digital UHF Radio With Display and Full Keypad
Kenwood's NX-5000 Series offers unsurpassed interoperability for a wide variety of users as it supports three digital CAIs — NXDN, DMR and P25 (Phase 1 & 2) — plus FM analog in a single radio. Best of all, a desired CAI can be selected at will, giving you the freedom to migrate at your own pace — whether you are intent on going fully digital, undecided about which digital system to pick, or just wanting to maintain both digital and analog for a while. An NX-5000 radio can simultaneously support two digital protocols plus analog, offering the following combinations: FM/DMR/ NXDN, FM/NXDN/P25, and FM/DMR/P25.
Feature Overview:
- Multi-Digital operation in NXDN, DMR, and P25 (Phase 1 & 2) protocols
- Any combination of two digital protocols can be selected from NXDN, DMR, and P25
- Mixed Digital & FM Analog Operation allows intelligent migration in mixed sites and easy migration with digital radios in other sites
- Large, Color 1.74" (240 x 180 pixels) Transflective TFT Display for better interface even in direct sunlight and with use of polarized sunglasses
- Easy to follow GUI for at-a-glance operational status checking and Multi-line Text to convey more information
- 4-way Directional-pad (D-pad) and 2-Position Lever Switch for intuitive control and operation
- Built-In GPS Receiver/Antenna for effective fleet management
- Bluetooth® Module built-in for hands-free operation
- Renowned KENWOOD Audio Quality can be achieved with Active Noise Reduction (ANR) that utilizes built-in DSP with two microphones for suppression of ambient noise
- Built-in 56-bit DES Encryption
- Optional 256-bit AES Encryption
- Over-the-Air Programming (OTAP)
- Built-in Motion Sensor for life-critical man down detection • microSD/SDHC (up to 2GB/32GB) Memory Card Slot
- IP67/68 and MIL-STD-810 C/D/E/F/G
Digital - NXDN Mode:
- Gen2 & NXDN Type-C Trunked Operation
- NXDN Conventional Operation
- 6.25 & 12.5 kHz Channels
- Over-the-Air Alias • Paging Call
- Emergency Call • All Group Call
- Status Messaging
- Remote Stun/Kill
- Remote Check
- Short & Long Data Messages
- NXDN Digital Scramble
Digital - DMR Mode:
- S-Trunking
- DMR Tier III Trunking
- DMR Tier II Conventional
- DMR Auto Slot Select
- Enhanced Encryption (40-bit)
- Site Roaming
- Two-slot TDMA in 12.5kHz channels
- Call Interruption
- Dual-slot Direct Mode
- Energy Efficient
Digital - P25 Mode:
- P25 Phase 1 Conventional/Trunked Operation
- P25 Phase 2 Trunked Operation
- Talk Group ID Lists
- Individual ID Lists
- Caller ID Display
- Remote Monitor/Remote Check
- Radio Inhibit
- Encryption Key Zeroize & Retention
- P25 Enhanced Encryption (ARC4)
- Over-the-Air Re-keying
FM Modes - General:
- Conventional & LTR Zones
- NPSPAC (USA only) Channels (±4.0 Modulation)
- FleetSync®/II: PTT ID ANI / Caller ID Display, Selective Group Call, Emergency Status / Text Messages
- MDC-1200: PTT ID ANI / Caller ID Display, Emergency, Radio Check / Inhibit
- QT / DQT & Two-Tone • Built-in Voice Inversion Scrambler
Contact Two Way Direct to Stay Connected
Once you’ve received your Kenwood NX-5300-ISCK3 two-way radio and start putting them to use on the job, you know you’ll have the support of a leading company for troubleshooting and recommendations of compatible accessories. Order with Two Way Direct for:
- The Lowest Price Guaranteed
- 24/7 Customer Support
- Low shipping costs – with free ground shipping
Use this Kenwood NX-5300-ISCK3 two-way radio with complete confidence. Order online or call 888-742-5893.
| Product Type: | Handheld Radios |
| Technology: | Digital & Analog (NXDN) |
| Compatible With (Brand): | Kenwood |
| Frequency Band: | UHF |
| Channels: | 1024 Channels |
| Power Output: | 5-Watts |
| Display: | Yes |
