Hytera

Discontinued Hytera RD622i DMR UHF 25-Watt Repeater

DISCONTINUED

Out of Stock
(0) Write a Review
SKU:
RD622i-U1
Availability:
Out of Stock

Description

RD622i

Indoor Wall Mountable Repeater

An indoor DMR and Analog dual mode repeater in a compact design, embedded with a power supply and optional mini duplexer. The Hytera DMR repeater's innovative design enables it to easily support wall- mount installation with AC/DC power. Multiple sites can connect via IP along with the RD982 to support flexible wide area and large building coverage. Integration with Hytera Dispatch System or other 3rd party GPS dispatching software can be achieved by the RJ45 port in the side of the repeater.
 
All-In-One Compact Design
Compact design, integrates RF, power supply, and optional duplexer into one box, which makes the Hytera RD622i smaller, lighter, and easier for wall-mount installation and indoor coverage (wall-mount bracket sold seperately BRK21).
 
Multi CTCSS / CDCSS Decode
This DMR UHF repeater decodes up to a maximum of 16 CDCSS/CTCSS codes in Analog channels allowing coverage for different Analog voice users from various groups.
 
Repeater Access Management
The repeater access control feature of the Hytera RD622i allows better security to prevent unauthorized users from accessing the radio network.
 
Analog Scan
This DMR UHF repeater has analog voice and signaling scan, allowing coverage of different analog voice users from various groups.
 
AC / DC Auto Switch
The Hytera RD622i integrates an internal power supply that supports a battery floating charge. The power supports 13.6V±15% DC and 90V-264V AC. If the AC power is cut off, the DC power (battery) automatically takes over without interruption.
 
Interoperability
Two repeaters can be interconnected to provide interoperability between UHF and VHF. A single repeater can auto switch between Analog and Digital mode, allowing for efficient frequency sharing between Analog and Digital users and an easy digital migration.
 
Digital Audio Streaming of Dual Time Slots
The streaming of both the voice slots via the rear port accessory pins on this Hytera DMR repeater, allowing for capability expansion via future development and recording of communications via Hytera Dispatch System.
 
Repeater Diagnostic And Control (RDAC)
Remote IP connection to monitor, diagnose, and control the repeater thus increasing maintenance efficiency. The Hytera developed RDAC is able to support multiple master network connections to allow the radio administrator to monitor multiple radio networks.
 
Multiple Sites via IP
Network connection via the IP port of this Hytera DMR repeater to form a privateradio network to meet data and voice communication needs for wide-area coverage and dispersed locations.
 
 
General data
Frequency range
VHF: 136 - 174 MHz
UHF: 400 - 470 MHz
Channel capacity
16
Channel spacing
12.5 / 20 / 25 kHz
Operating voltage
13.6 ± 15% VDC
90 V - 264 VAC
Max. power consumption (Standby)
≤ 0.5 A
Max. power consumption (Transmit)
≤ 5.5 A
Frequency stability
±0.5 ppm
Antenna impedance
50 Ω
Duty Cycle 100%
Dimensions (H × W × D)
11.85 x 7.24 x 2 inches
Weight
6.61 lbs
 
Transmitter
Transmitting power
1 – 25 W continuous
Modulation
11K0F3E at 12.5 kHz
14K0F3E at 20 kHz
16K0F3E at 25 kHz
4FSK digital modulation
12.5 kHz (data only): 7K60FXD
12.5 kHz (data and voice): 7K60FXW
Interfering signals and harmonics
-36 dBm < 1 GHz
-30 dBm > 1 GHz
Modulation limiting
±2.5 kHz at 12.5 kHz
±4.0 kHz at 20 kHz
±5.0 kHz at 25 kHz
Noise suppression
40 dB at 12.5 kHz
43 dB at 20 kHz
45 dB at 25 kHz
Adjacent channel selectivity
60 dB at 12,5 kHz
70 dB at 20/25 kHz
Audio sensitivity
+1 dB to -3 dB
Nominal audio distortion
≤ 3 %
Digital vocoder type
AMBE++ or SELP
 
Digital Protocol ETSI-TS102 361-1, 2&3
 
Receiver
Sensitivity (analog)
0.3 μV (12 dB SINAD)
0.22 μV (typical) (12 dB SINAD)
0.4 μV (20 dB SINAD)
Sensitivity (digital)
0.3 μV / BER 5%
Adjacent channel selectivity
TIA-603
ETSI

65 dB at 12.5 kHz / 75 dB at 20 and 25 kHz
60 dB at 12.5 kHz / 70 dB at 20 and 25 kHz
Intermodulation
TIA-603
ETSI

75 dB at 12.5/20/25 kHz
70 dB at 12.5/20/25 kHz
Spurious response rejection
TIA-603
ETSI

75 dB at 12.5/20/25 kHz
70 dB at 12.5/20/25 kHz
Hum and noise
40 dB at 12.5 kHz
43 dB at 20 kHz
45 dB at 25 kHz
Nominal audio distortion
≤ 3 %
Audio sensitivity
+1 dB to -3 dB
Conducted spurious emission
< -57 dBm
 
Environmental Specs
Operating temperature range
-30 °C to +60 °C
Storage temperature range
-40 °C to +85 °C
 
All technical indications were tested according to the corresponding standards. Subject to change on the basis of continuous development.

Warranty Information

3-Year Factory Warranty

Specifications

Product Type:
Repeaters
Technology:
Digital & Analog (TDMA)
Frequency Band:
UHF
Power Output:
25-Watts
Display:
No